LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2002 >> Sentra SE-R, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Automatic Transaxle Re4F04B) >> Repair For Component Parts >> Oil Pump >> Assembly
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Oil Pump: Assembly

WARNING: This page is about a different variant/trim than selected.
  1. Install oil seal on oil pump housing.
    Fig 1: Installing Oil Seal On Oil Pump Housing
    G02017038Courtesy of NISSAN MOTOR CO., U.S.A.
  2. Install O-ring on oil pump housing.
    • Apply ATF to O-ring. 
    Fig 2: Installing O-Ring On Oil Pump Housing
    G02017039Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Install inner and outer gears on oil pump housing.
    • Be careful of direction of inner gear. 
    Fig 3: Installing Inner And Outer Gears On Oil Pump Housing
    G02017040Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Install oil pump cover on oil pump housing.
    1. Wrap masking tape around splines of oil pump cover assembly to protect seal. Position oil pump cover assembly on oil pump housing assembly, then remove masking tape.
    2. Tighten bolts in a crisscross pattern. Tighten oil pump cover bolts to the specified torque. Refer to COMPONENTS .
      Fig 4: Tightening Oil Pump Cover Bolts In Sequence
      G02017041Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Install new seal rings carefully after packing ring groove with petroleum jelly.
    • Do not spread gap of seal ring excessively while installing. The ring may be deformed. 
    Fig 5: Installing Oil Pump Seal Ring
    G02017042Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals