LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2003 >> Frontier Base, Automatic >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls - Self-Diagnostics >> Diagnostic Tests >> DTC P0455: EVAP Control System >> DTC Confirmation Test (Using Generic Scan Tool)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Confirmation Test (Using Generic Scan Tool)

  1. Drive vehicle according to specified driving pattern to set System Readiness Test (SRT) codes. See SYSTEM READINESS TEST  under SELF-DIAGNOSTIC SYSTEM.
  2. Select MODE 1 on scan tool and check SRT status of EVAP system. If EVAP system SRT is complete, system is okay at this time. If EVAP system SRT is incomplete, turn ignition off, wait at least 10 seconds and go to next step.
    3. NOTE: It is not necessary to allow engine to cool before driving vehicle.
  3. Perform driving pattern again. Stop vehicle and select MODE 3 on scan tool.
    • If DTC P0455 is displayed, go to DIAGNOSTIC PROCEDURE  .
    • If DTCs P0442 or P1442 is displayed, go to DIAGNOSTIC PROCEDURE  under DTC P0442: EVAP CONTROL SYSTEM.
    • If DTC P0441 is displayed, go to DIAGNOSTIC PROCEDURE  under DTC P0441: EVAP CONTROL SYSTEM.
    • If DTCs P0441, DTC P0442, DTC P0455 or DTC P1442 is not displayed, go to next step.
  4. Select MODE 1 on scan tool. If EVAP system SRT is complete, system is okay at this time. If EVAP system SRT is incomplete, go to step  2 .
scientia non olet · About LEMON Manuals