DTC Confirmation Test (Using CONSULT-II)

Turn ignition on. Select P/N POSI SW in DATA MONITOR mode with CONSULT-II.
Check P/N POSI SW signal under the following conditions.
- With transmission in Park or Neutral, ON should be displayed.
- With transmission not in Park or Neutral, OFF should be displayed.
If operation is as specified, go to next step. If operation is not as specified, go to appropriate DIAGNOSTIC PROCEDURE.
Select DATA MONITOR mode with CONSULT-II. Start engine and warm to normal operating temperature.
Maintain the following conditions for at least 60 consecutive seconds:
2.4L Models -
- ENG SPEED: 1400-4000 RPM.
- COOLAN TEMP/S: more than 158°F (70°C).
- B/FUEL SCHDL: 3.5-17.8 msec.
- VHCL SPEED SE: more than 40 MPH.
3.3L Models -
- ENG SPEED: 1600-2700 RPM.
- COOLAN TEMP/S: more than 158°F (70°C).
- B/FUEL SCHDL: 3.3-13.0 msec.
- VHCL SPEED SE: more than 40 MPH.
If 1st trip DTC is detected, go to appropriate DIAGNOSTIC PROCEDURE. If 1st trip DTC is not detected, system is okay at this time.