With CONSULT-II

WARNING: This page is about a different car, the 2004 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition switch ON and wait at least 1 second.
Select "DATA MONITOR" mode with CONSULT-II.
Start engine and let it idle for 1 second.
Turn ignition switch OFF, wait at least 10 seconds, and then turn ON.
Repeat steps 3 and 4 for 4 times.
If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE "

Fig 1: DTC Confirmation Procedure With CONSULT-II (P1065)
Courtesy of NISSAN MOTOR CO., U.S.A.