LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2003 >> Sentra SE-R, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 2159 (Brake System) >> Unit Disassembly And Assembly >> Front Disc Brake >> Disassembly and Assembly >> Assembly
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Disassembly and Assembly: Assembly

WARNING: This page is about a different car, the 2011 Nissan Xterra. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Use NISSAN Rubber Grease when assembling.
  1. Install the bleed valve and cap.
  2. Apply rubber grease to the new piston seals (1) and insert the new piston seals (1) into the groove on the cylinder body.
    CAUTION: Do not reuse piston seals.
    Fig 1: Inserting New Piston Seals Into Groove On Cylinder Body
    G07155349
  3. Apply rubber grease to the new piston boots (1). Cover the piston end (2) with the piston boot (1), and then install the cylinder side lip on the piston boot (1) securely into the groove on the cylinder body.
    CAUTION:
    • Do not reuse piston boot.
    • Press pistons in evenly and vary the pressing points to prevent the cylinder inner wall from being damaged.
      Fig 2: Applying Rubber Grease To New Piston Boot
      G07155350
  4. Install the pistons (1) into the cylinder body and insert the piston boots (2) side lip into the piston groove as shown.
    CAUTION: Press pistons in evenly and vary the pressing points to prevent the cylinder inner wall from being damaged.
    Fig 3: Identifying Pistons And Piston Boots
    G07155351
  5. Apply rubber grease to the sliding pin boots, then install the new upper sliding pin, lower sliding pin, and sliding pin boots on the torque member.
    CAUTION: Upper sliding pin must be replaced at each service.
  6. Install the caliper body on the torque member. Refer to "REMOVAL AND INSTALLATION OF BRAKE CALIPER AND DISC ROTOR ".
scientia non olet · About LEMON Manuals