Consult-II Inspection Procedure

WARNING: This page is about a different car, the 2004 Infiniti M45 and 2003 Infiniti M45. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition switch OFF.
Connect CONSULT-II and CONSULT-II CONVERTER to data link connector.

Fig 1: Locating Data Link Connector
Courtesy of NISSAN MOTOR CO., U.S.A.
Turn ignition switch ON.
Turn ASCD main switch ON.
Touch START (NISSAN BASED VHCL) (on CONSULT-II display).
Touch ASCD.
If "ASCD" is not indicated, go to CONSULT-II DATA LINK CONNECTOR (DLC) CIRCUIT .

Fig 2: CONSULT-II Menu Screen
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch SELF-DIAG RESULTS.

Fig 3: Selecting SELF-DIAG RESULTS Menu
Courtesy of NISSAN MOTOR CO., U.S.A.
- Self-diagnostic results are shown on display
  Refer to CONSULT-II SELF-DIAGNOSTIC RESULTS .
Fig 4: Self-Diagnostic Results Display Screen
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch DATA MONITOR.

Fig 5: Selecting DATA MONITOR Menu
Courtesy of NISSAN MOTOR CO., U.S.A.
- Touch START.
- Data monitor results are shown on display
  Refer to CONSULT-II SELF-DIAGNOSTIC RESULTS .
  
  For further information, read the CONSULT-II Operation Manual .

Fig 6: Data Monitor Results on Display

Courtesy of NISSAN MOTOR CO., U.S.A.