16. Check EVAP Control System Pressure Sensor Shield Circuit For Open And Short
WARNING: This page is about a different car, the 2004 Infiniti M45. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect harness connectors B401, B251.
- Check continuity between harness connector B251 terminal 5 and ground.
Refer to WIRING DIAGRAM .
Continuity should exist.
- Also check harness for short to power.
- Then reconnect harness connectors B401, B251.
OK or NG
- OK: GO TO 18. CHECK INTERMITTENT INCIDENT .
- NG: GO TO 17