Removal And Installation: Installation

WARNING: This page is about a different car, the 2003 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.

Pay attention to the following when installing wheel sensor. Tighten installation bolts and nuts to the specified torques.

When installing, make sure there is no foreign material such as iron chips on and in the mounting hole of the wheel sensor. Make sure no foreign material has been caught in the sensor rotor. Remove any foreign material and clean the mount.
When installing wheel sensor, be sure to press rubber grommets in until they lock at locations shown in Figure. When installed, harness must not be twisted.