2. Check Harness Connector Output Signal

WARNING: This page is about a different car, the 2004 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect fuel level sensor unit and fuel pump connector.
Turn ignition switch ON.
Check voltage between combination meter harness connector M24 terminal 15 (Y/L) and ground.
- Battery voltage

OK or NG

OK >> GO TO 3.

NG >> Replace the combination meter. Refer to Removal and Installation of Combination Meter .

Fig 1: Identifying Combination Meter Test Terminal

Courtesy of NISSAN MOTOR CO., U.S.A.