Real Time Diagnosis In Data Monitor Mode (Recording Vehicle Data): Description

CONSULT-II has two kinds of triggers and they can be selected by touching "SETTING" in "DATA MONITOR" mode.

1. "AUTO TRIG" (Automatic trigger):
   • The malfunction will be identified on the CONSULT-II screen in real time.

     In other words, DTC/1st trip DTC and malfunction item will be displayed if the malfunction is detected by ECM.

     At the moment a malfunction is detected by ECM, "MONITOR" in "DATA MONITOR" screen is changed to "Recording Data.. xx%" as shown at left, and the data after the malfunction detection is recorded. Then the percentage reached 100%, "REAL-TIME DIAG" screen is displayed. If stop is touched on the screen during "Recording Data..XX," "Real time diag" screen is also displayed.

     The recording time after the malfunction detection and the recording speed can be changed by "TRIGGER POINT" and "RECORDING Speed". Refer to CONSULT-II Operation Manual.

2. "MANU TRIG" (Manual trigger):
   • DTC/1st trip DTC and malfunction item will not be displayed automatically on CONSULT-II screen even though a malfunction is detected by ECM.

     "DATA MONITOR" can be performed continuously even though a malfunction is detected.

     Use these triggers as follows: