With CONSULT-II

Reconnect all harness connectors disconnected.
Start engine and warm it up to normal operating temperature.
Stop engine and turn ignition switch ON.
Select "DATA MONITOR" mode with CONSULT-II.

Fig 1: Scan Tool Display - Data Monitor
Courtesy of NISSAN MOTOR CO., U.S.A.
Check voltage of "THRTL POS SEN" under the following conditions.

NOTE: Voltage measurement must be made with throttle position sensor installed in vehicle.

Fig 2: Voltage Chart

Courtesy of NISSAN MOTOR CO., U.S.A.

If NG, adjust closed throttle position switch. Refer to Basic Inspection .