Overall Function Check

Use this procedure to check the overall function of the heated oxygen sensor 1 circuit. During this check, a DTC might not be confirmed.

WITH GST 

1. Start engine and warm it up to normal operating temperature.
2. Set voltmeter probes between ECM terminal 50 (Heated oxygen sensor 1 signal) and engine ground.
3. Check the following with engine speed held at 2,000 RPM constant under no load.
   • The maximum voltage is over 0.6V at least 1 time.
   • The minimum voltage is over 0.1V at least 1 time.
4. If NG, go to "DIAGNOSTIC PROCEDURE ".

Fig 1: Setting Voltmeter Probes Between ECM Terminal And Engine Ground

Courtesy of NISSAN MOTOR CO., U.S.A.