Overall Function Check
Use this procedure to check the overall function of the A/F sensor 1 circuit. During this check, a 1st trip DTC might not be confirmed.
With GST
- Start engine and warm it up to normal operating temperature.
- Drive the vehicle at a speed of 80 km/h (50 MPH) for a few minutes in D position with "OD" OFF (A/T) or 3rd position (M/T).NOTE: Keep accelerator pedal as steady as possible during the cruising.
- Set D position with "OD" ON (A/T) or 4th position (M/T), then release the accelerator pedal fully until the vehicle speed decreases to 50 km/h (30 MPH).NOTE: Never apply brake during releasing the accelerator pedal.
- Repeat steps 2 to 3 five times.
- Stop the vehicle and turn ignition switch OFF.
- Wait at least 10 seconds and restart engine.
- Repeat steps 2 to 3 five times.
- Stop the vehicle and connect GST to the vehicle.
- Make sure that no DTC is displayed.
If the DTC is displayed, go to DIAGNOSTIC PROCEDURE .