DTC Confirmation Procedure

CAUTION: Always drive vehicle at a safe speed.

NOTE: If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

TESTING CONDITION:

Steps 3 and 4 may be conducted with the drive wheels lifted in the shop or by driving the vehicle. If a road test is expected to be easier, it is unnecessary to lift the vehicle.

WITH CONSULT-II

Start engine.
Select "DATA MONITOR" mode with CONSULT-II.
Drive the vehicle for at least 5 consecutive seconds under the following condition.

Fig 1: Vehicle Driving Conditions (1 Of 2)
Courtesy of NISSAN MOTOR CO., U.S.A.

If trip DTC is detected, go to DIAGNOSTIC PROCEDURE .

If trip DTC is not detected, go to the following step.
Drive the vehicle for at least 5 consecutive seconds under the following condition.

Fig 2: Vehicle Driving Conditions (2 Of 2)
Courtesy of NISSAN MOTOR CO., U.S.A.
If trip DTC is detected, go to DIAGNOSTIC PROCEDURE .

WITH GST

Follow the procedure "WITH CONSULT-II" above.