Diagnostic Procedure

INSPECTION START
WITH CONSULT-II
1. Turn ignition switch ON.
2. Select "SELF DIAG RESULTS" mode with CONSULT-II.
3. Touch "ERASE".
4. Perform DTC Confirmation Procedure.
  See DTC CONFIRMATION PROCEDURE .
5. Is the 1st trip DTC P0605 displayed again?
WITH GST
1. Turn ignition switch ON.
2. Select MODE 4 with GST.
3. Touch "ERASE".
4. Perform DTC Confirmation Procedure.
  See DTC CONFIRMATION PROCEDURE .
5. Is the 1st trip DTC P0605 displayed again?
Yes or No
1. Yes: GO TO 2.
2. No: INSPECTION END
REPLACE ECM
1. Replace ECM.
2. Perform initialization of NATS system and registration of all NATS ignition key IDs. Refer to "NVIS (NISSAN VEHICLE IMMOBILIZER SYSTEM - NATS) ".
3. Perform "ACCELERATOR PEDAL RELEASED POSITION LEARNING ".
4. Perform "THROTTLE VALVE CLOSED POSITION LEARNING ".
5. Perform "IDLE AIR VOLUME LEARNING ".
1. INSPECTION END