With Consult-II

Perform "IDLE AIR VOLUME LEARNING ". Make sure that "CMPLT" is displayed on CONSULT-II screen. If "INCMP" is displayed, follow the instruction for Idle Air Volume Learning.
Select "A/F SEN1 (B1) P1278/P1279" of "A/F SEN1" in "DTC WORK SUPPORT" mode.
Touch "START".
When the following conditions are met, "TESTING" will be displayed on the CONSULT-II screen.

Fig 1: Specifications Table
Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 2: Displaying OUT OF CONDITION With Consult-II Screen
Courtesy of NISSAN MOTOR CO., U.S.A.

If "TESTING" is not displayed after 20 seconds, retry from step 2.
Following the instructions of CONSULT-II screen, set D position with "OD" OFF and release accelerator pedal fully.

Fig 3: Displaying TESTING With Consult-II
Courtesy of NISSAN MOTOR CO., U.S.A.
Make sure that "TESTING" changes to "COMPLETED".
If "TESTING" changed to "OUT OF CONDITION", retry from step 6.
Make sure that "OK" is displayed after touching "SELF-DIAG RESULT".
If "NG" is displayed, go to "DIAGNOSTIC PROCEDURE ".

Fig 4: Displaying COMPLETED With Consult-II Screen
Courtesy of NISSAN MOTOR CO., U.S.A.