Automatic Operation

WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

AUTOMATIC OPERATION SPECIFICATION

Function		Description
Memory operation		The seat, pedal (accelerator, brake) and door mirror move to the stored driving position by pushing seat memory switch (1 or 2).
Entry/Exiting function	Exiting operation	At Exit, the seat moves backward. (Exiting position)
Entry/Exiting function	Entry operation	At entry, the seat returns from Exiting position to the previous driving position before the Exiting operation.
Key fob interlock operation		Perform memory operation, turnout operation and return operation by pressing key fob unlock button.

NOTE:

Disconnecting the battery erases the stored memory.
After connecting the battery, insert the key into the ignition cylinder and turn the front door switch LH ON (open)-->OFF (close)-->ON (open), the Entry/Exiting function becomes possible.
After Exiting operation is carried out, return operation can be operated.

AUTOMATIC OPERATION SPECIFICATION

Auto operation temporary stop conditions.

When ignition switch is turned to START during seat memory switch operation and return operation, seat memory switch operation and return operation is stopped.

Auto operation stop conditions.

When the vehicle speed becomes 7 km/h (4 MPH) or higher (memory switch operation and entry operation).
When the setting switch, seat memory switch 1, or 2 are pressed.
When A/T shift lever is in any position other than P.
When the door mirror switch is operated (when ignition switch turned to ON).
When power seat switch turned ON.
When pedal adjusting switch turned ON.
When front seat sliding Entry/Exiting setting is OFF (entry/exiting operation).

NOTE: During automatic operation, if the ignition switch is turned ON-->START, the automatic operation is suspended. When the ignition switch returns to ON, it resumes.