LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 1404 (Brake Control System) >> Wheel Sensors >> Removal and Installation >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal and Installation: Installation

WARNING: This page is about a different car, the 2005 Infiniti FX45 and 2005 Infiniti FX35. However, it is still accessible from the selected car via links, so may be relevant.

Note the following, and install in the reverse order of removal.

CAUTION: Be careful of the following when installing sensor. Tighten installation bolts to specified torques.
  • When installing, make sure there is no foreign material such as iron chips on pick-up and mounting hole of sensor. Make sure no foreign material has been caught in the sensor rotor. Remove any foreign material and clean the mount. 
  • When installing front sensor, be sure to press rubber grommets in until they lock at the three locations shown in the figure (2 at shock absorbers and 1 at body panel). When installed, harness must not be twisted. White line on harness must be visible from front. 
  • When installing rear sensor, attach harness at rear suspension member securely. Besides, harness must not be twisted when installed. 
scientia non olet · About LEMON Manuals