LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 154 (Power Windows) >> Component Tests >> Power Window Motor PTC Thermistor (Driver)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Power Window Motor PTC Thermistor (Driver)

WARNING: This page is about a different car, the 2003 Lexus RX 300 and 2002 Lexus RX 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the connector from the power window motor.
  2. Connect the positive (+) lead from the ammeter to terminal No. 1 on the wiring harness side connector and the negative (-) lead to negative terminal of the battery. See CONNECTOR IDENTIFICATION .
  3. Connect the positive (+) lead from the battery to terminal No. 2 on the wiring harness side connector, and raise the window to the fully closed position.
  4. Continue to apply voltage, and check that the current changes to less than 1 amp within 4-90 seconds.
  5. Disconnect the leads from the terminals.
  6. Approximately 60 seconds later, connect the positive (+) lead from the battery to terminal No. 1 and negative (-) lead to terminal No. 2, and check that the window begins to descend. If operation is not as specified, replace the motor. See WINDOW REGULATOR (FRONT DOOR)  under REMOVAL & INSTALLATION.
scientia non olet · About LEMON Manuals