Reference Value From Consult-II
WARNING: This page is about a different car, the 2005 Nissan Frontier. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
The display shows the control unit calculation data, so a normal value might be displayed even in the event the output circuit (harness) is open or short circuited.
DATA MONITOR SPECIFICATION
| Monitor item | Display content | Data monitor |
NOTE:
Error inspection checklist
|
|||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Condition | Reference value in normal operation | |||||||||||
| FR RH SENSOR FR LH SENSOR RR RH SENSOR RR LH SENSOR |
Wheel speed | Vehicle stopped | 0 [km/h (MPH)] | "WHEEL SENSOR SYSTEM " | ||||||||
| Vehicle running ((1)) | Almost in accordance with speedometer display (within +/-10%) | |||||||||||
| BATTERY VOLT | Battery voltage supplied to ABS actuator and electric unit (control unit) | Ignition switch ON | 10 to 16V | "ABS CONTROL UNIT POWER AND GROUND SYSTEMS INSPECTION " | ||||||||
| CRANKING SIG | Cranking status | Cranking | (3) | - | ||||||||
| Not cranking | (4) | |||||||||||
| STOP LAMP SW | Stop lamp switch operation | Brake pedal depressed | (3) | - | ||||||||
| Brake pedal not depressed | (4) | |||||||||||
| ABS WARN LAMP | ABS warning lamp ON condition ((2)) | ABS warning lamp ON | (3) | "ABS WARNING LAMP DOES NOT COME ON WHEN IGNITION SWITCH IS TURNED ON " | ||||||||
| ABS warning lamp OFF | (4) | |||||||||||
| EBD WARN LAMP | EBD warning lamp status | When EBD warning lamp is on | (3) | "CAN COMMUNICATION SYSTEM INSPECTION " | ||||||||
| When EBD warning lamp is off | (4) | |||||||||||
| MOTOR RELAY | Operation status of motor and motor relay | Ignition switch ON or running (ABS not activated) | (4) | "ACTUATOR MOTOR, MOTOR RELAY, AND CIRCUIT INSPECTION " | ||||||||
| Ignition switch ON or engine running (ABS activated) | (3) | |||||||||||
| ACTUATOR RLY | Actuator relay operation status | Vehicle stopped (Ignition switch ON) | (4) | "ACTUATOR MOTOR, MOTOR RELAY, AND CIRCUIT INSPECTION " | ||||||||
| Vehicle stopped (Engine running) | (3) | |||||||||||
| FR LH IN SOL FR LH OUT SOL FR RH IN SOL FR RH OUT SOL REAR IN SOL REAR OUT SOL |
Solenoid valve operation | Actuator (solenoid) is active ("ACTIVE TEST" with CONSULT-II) or actuator relay is inactive (in fail-safe mode). | (3) | "SOLENOID VALVE SYSTEM INSPECTION " | ||||||||
| When actuator (solenoid) is not active and actuator relay is active (ignition switch ON). | (4) | |||||||||||
| ABS SIGNAL EBD SIGNAL |
Signal status | ABS active EBD active |
(3) | ABS system EBD system |
||||||||
| ABS not active EBD not active |
(4) | |||||||||||
| ABS FAIL SIG EBD FAIL SIG |
Fail signal status | ABS fail EBD fail |
(3) | ABS system EBD system |
||||||||
| ABS normal EBD normal |
(4) | |||||||||||
|
||||||||||||