Changing Engine Oil

WARNING: This page is about a different car, the 2006 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Be careful not to burn yourself, as the engine oil may be hot.
Prolonged and repeated contact with used engine oil may cause skin cancer; try to avoid direct skin contact with used oil. If skin contact is made, wash thoroughly with soap or hand cleaner as soon as possible.

Park the vehicle on a flat and level surface, then start the engine to warm up the oil.
Check for oil leaks from the engine.
Stop the engine and wait for 10 minutes.
Remove the oil drain plug and oil filler cap.
Drain the engine oil.
Install the drain plug.
Oil pan drain plug : 34.3 N.m (3.5 kg-m, 25 ft-lb)
CAUTION:
- Clean drain plug and install with new washer.
  
  Fig 1: Removing Oil Drain Plug And Oil Filler Cap
  Courtesy of NISSAN MOTOR CO., U.S.A.
Refill the engine with the specified new engine oil. Refer to "RECOMMENDED FLUIDS AND LUBRICANTS ".
CAUTION:
- The refill capacity depends on the oil temperature and drain time. Use these specifications for reference only.
- Always use the dipstick to determine when the proper amount of oil is in the engine.
Warm up the engine and check the area around the drain plug and oil filter for oil leaks.
Stop the engine and wait for 10 minutes.
Check the oil level. Refer to "ENGINE OIL LEVEL ".

Fig 2: Checking Oil Level On Dipstick
Courtesy of NISSAN MOTOR CO., U.S.A.