Reference Value From Consult-II
WARNING: This page is about a different car, the 2006 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
The display shows the control unit calculation data, so a normal value might be displayed even in the event the output circuit (harness) is open or short circuited.
CONSULT-II REFERENCE VALUES
| Monitor item | Display content | Data monitor |
NOTE:
Error inspection checklist
|
|
|---|---|---|---|---|
| Condition | Reference value in normal operation | |||
| P POSI SIG | A/T gear position | P position | ON | , "CAN COMMUNICATION SYSTEM INSPECTION " |
| Other than P position | OFF | |||
| N POSI SIG | A/T gear position | N position | ON | |
| Other than N position | OFF | |||
| GEAR | A/T gear position | 1st gear | 1 | |
| 2nd gear | 2 | |||
| 3rd gear | 3 | |||
| 4th gear | 4 | |||
| FR RH SENSOR FR LH SENSOR RR RH SENSOR RR LH SENSOR |
Wheel speed | Vehicle stopped | 0 [km/h (MPH)] | , "WHEEL SENSOR SYSTEM INSPECTION " |
| Vehicle running (Note 1) | Almost in accordance with speedometer display (within +/-10%) | |||
| ACCEL POS SIG | Open/close condition of throttle valve (linked with accelerator pedal). | Accelerator pedal not depressed (ignition switch is ON) | 0% | , "CAN COMMUNICATION SYSTEM INSPECTION " |
| Depress accelerator pedal (ignition switch is ON) | 0 to 100% | |||
| ENGINE SPEED | With engine running | With engine stopped | 0 rpm | , "ENGINE SYSTEM INSPECTION " |
| Engine running | Almost in accordance with tachometer display | |||
| BATTERY VOLT | Battery voltage supplied to ABS actuator and electric unit (control unit) | Ignition switch ON | 10 to 16V | , "ABS/TCS CONTROL UNIT POWER AND GROUND SYSTEMS INSPECTION " |
| CRANKING SIG | Cranking status | Cranking | ON | - |
| Not cranking | OFF | |||
| STOP LAMP SW | Brake pedal operation | Brake pedal depressed | ON | , "STOP LAMP SWITCH SYSTEM INSPECTION " |
| Brake pedal not depressed | OFF | |||
| ABS WARN LAMP | ABS warning lamp ON condition (Note 2) | ABS warning lamp ON | ON | , "ABS WARNING LAMP DOES NOT COME ON WHEN IGNITION SWITCH IS TURNED ON " |
| ABS warning lamp OFF | OFF | |||
| MOTOR RELAY | Operation status of motor and motor relay | Ignition switch ON or engine running (ABS not activated) | OFF | , "ACTUATOR MOTOR, MOTOR RELAY, AND CIRCUIT INSPECTION " |
| Ignition switch ON or engine running (ABS activated) | ON | |||
| ACTUATOR RLY | Actuator relay operation status | Vehicle stopped (Ignition switch ON) | OFF | |
| Vehicle stopped (Engine running) | ON | |||
| SLIP LAMP | SLIP indicator lamp status (Note 3) | When SLIP indicator lamp is ON | ON | , "COMBINATION METER " |
| When SLIP indicator lamp is OFF | OFF | |||
| OFF LAMP | TCS OFF indicator lamp status | When TCS OFF indicator lamp is ON | ON | , "CAN COMMUNICATION SYSTEM INSPECTION " |
| When TCS OFF indicator lamp is OFF | OFF | |||
| EBD WARN LAMP | EBD warning lamp status | When EBD warning lamp is ON | ON | , "CAN COMMUNICATION SYSTEM INSPECTION " |
| When EBD warning lamp is OFF | OFF | |||
| OFF SW | TCS OFF switch ON/OFF status | TCS OFF switch ON (When TCS OFF indicator lamp is ON) | ON | , "TCS OFF SWITCH " |
| TCS OFF switch OFF (When TCS OFF indicator lamp is OFF) | OFF | |||
| ASCD SIGNAL | ASCD operation condition | ASCD activated | ON | ASCD and circuit |
| ASCD not activated | OFF | |||
| FR LH IN SOL FR LH OUT SOL FR RH IN SOL FR RH OUT SOL RR RH IN SOL RR RH OUT SOL RR LH IN SOL RR LH OUT SOL |
Solenoid valve operation | Actuator (solenoid) is active ("ACTIVE TEST" with CONSULT-II) or actuator relay is inactive (in fail-safe mode). | ON | - |
| When actuator (solenoid) is not active and actuator relay is active (ignition switch ON). | OFF | |||
| TCS SIGNAL ABS SIGNAL EBD SIGNAL |
Signal status | TCS active ABS active EBD active |
ON | TCS system ABS system EBD system |
| TCS not active ABS not active EBD not active |
OFF | |||
| TCS FAIL SIG ABS FAIL SIG EBD FAIL SIG |
Fail signal status | TCS fail ABS fail EBD fail |
OFF | TCS system ABS system EBD system |
| Note 1: Confirm tire pressure is normal. Note 2: ON/OFF timing of ABS warning lamp ON: For approximately 2 seconds after ignition switch is turned ON, or when a malfunction is detected. OFF: Approximately 2 seconds after ignition switch is turned ON (when system is in normal operation) and TCS function is not activated. Note 3: SLIP indicator lamp ON/OFF timing ON: For approximately 2 seconds after ignition switch is turned ON, or when a malfunction is detected and TCS function is activated while driving. OFF: Approximately 2 seconds after ignition switch is turned ON (when system is in normal operation) and TCS function is not activated. Flashing: TCS function is active during driving. |
||||