LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 1944 (Meter) >> Meter / Gauge System >> Customize Parameters
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Customize Parameters

WARNING: This page is about a different car, the 2006 Scion tC. However, it is still accessible from the selected car via links, so may be relevant.
  1. BUZZER ON / OFF SETTING 
    1. Check that the ODO display is on, and turn the ignition switch OFF and then ON. If another display is on, change it to the ODO display.
    2. Within 2 to 6 seconds after turning the ignition switch ON, push the ODO / TRIP switch and hold it for 10 seconds or more.
    3. Following the table below, set buzzer cancel setting.
      BUZZER OPERATION CHART

      Buzzer Operation
      Seat belt for driver's seat Front seat inner belt (driver side) OFF --> ON
      (Seat belt unfastened --> fastened)

      HINT:

      The ODO / TRIP display changes from "b-on" to "boff" when entering the cancel mode.

    4. During the cancel mode, each time the ODO / TRIP switch is pushed, the setting is switched between bon and b-off.

      HINT:

      b-on: Cancel is invalid

      b-off: Cancel is valid

    5. After the setting, the mode will be canceled by either not operating the switch for 10 seconds or more, or turning the ignition switch from ON to OFF.

      HINT:

      The setting can be reset when reconnecting the battery connector or removing / installing the meter connector (Buzzer on).

scientia non olet · About LEMON Manuals