Bleeding Brake System
WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
While bleeding, monitor the master cylinder brake fluid level.
- Turn ignition switch OFF and disconnect battery negative cable.
- Connect a vinyl tube to the rear right bleed valve.
- Fully depress brake pedal 4 to 5 times.
- With brake pedal depressed, loosen bleed valve to let the air out, and then tighten it immediately.
- Repeat steps 3 and 4 until no more air comes out.
- Tighten bleed valve to the specified torque. Refer to "COMPONENTS " (front disc brake), "COMPONENTS " (rear disc brake).
- Perform steps 2 to 6 at each wheel, with master cylinder reservoir tank filled at least half way, bleed air from the front left, rear left, and front right bleed valve, in that order.