Remote Keyless Entry System Operation

WARNING: This page is about a different car, the 2007 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

When the remote keyless entry system is triggered by input from the keyfob, the BCM, interpreting it as turn signal is ON, outputs turn signal from BCM terminals 60 and 61.

The BCM supplies power

through BCM terminals 60 and 61
to front combination lamp LH and RH terminal 7
through front combination lamp LH and RH terminal 6
to grounds E9, E15 and E24, and
to rear combination lamp LH terminal 3
through rear combination lamp LH terminal 5
to grounds B7 and B19, and
to rear combination lamp RH terminal 3
through rear combination lamp RH terminal 5
to grounds B117 and B132.

BCM sends signal to combination meter through CAN communication lines and turns on turn signal indicator lamps within combination meter.

With power and input supplied, the BCM controls the flashing of the hazard warning lamps when keyfob is used to activate the remote keyless entry system.