Cornering Lamp Does Not Operate

With CONSULT-III

1. Select "IPDM E/R" on CONSULT-III, and select "ACTIVE TEST" on "SELECT DIAG MODE" screen.
2. Select "CORNERING LAMP" during active test.
3. Select "RH", then "LH" on "ACTIVE TEST" screen.
4. Make sure cornering lamp LH and RH operate.

Without CONSULT-III

GO TO  3.

OK or NG 

OK: GO TO 2.

NG: GO TO  3.

1. Select "IPDM E/R" on CONSULT-III, and select "DATA MONITOR" on "SELECT DIAG MODE" screen.
2. Make sure "CRNRNG LMP REQ" turns ON-OFF linked with operation of lighting switch.
   NOTE: Lighting switch must not be in OFF position.

   When lighting switch is in TURN RH position : CRNRNG LMP REQ R 

   When lighting switch is in TURN LH position : CRNRNG LMP REQ L 

OK or NG 

OK: Replace IPDM E/R. Refer to "REMOVAL AND INSTALLATION OF IPDM E/R ".

NG: Replace BCM. Refer to "REMOVAL AND INSTALLATION OF BCM ".

Check bulb standard of each cornering lamp is correct. Refer to "EXTERIOR LAMP ".

OK or NG 

OK: GO TO 4.

NG: Replace cornering lamp bulb. Refer to "BULB REPLACEMENT ".

1. Turn ignition switch OFF.
2. Disconnect IPDM E/R connectors and front combination lamp LH and RH connectors.
3. Check continuity between IPDM E/R harness connector terminal and front combination lamp harness connector terminal.
   CONTINUITY REFERENCE CHART
   
   

   A			B			Continuity
   IPDM E/R connector		Terminal	Front combination lamp connector		Terminal
   RH	E122	23	RH	E137	7	Yes
   LH	E124	34	LH	E43

   Fig 1: Checking Continuity Between IPDM E/R Connector Terminals 23 & 24 And Front Combination Lamp Connector Terminal 7

   Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK: GO TO 5.

NG: Repair harness or connector.

Check continuity between front combination lamp harness connector terminal and ground.

OK or NG 

OK: Replace IPDM E/R. Refer to "REMOVAL AND INSTALLATION OF IPDM E/R ".

NG: Repair harness or connector.

Fig 2: Checking Continuity Between Front Combination Lamp Connector Terminal 8 And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.