LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 2099 (Lighting System) >> Front Fog Lamp >> Front Fog Lamp Assembly >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Front Fog Lamp Assembly: Removal

WARNING: This page is about a different car, the 2008 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Do not touch the glass of bulb directly by hand. Keep grease and other oily substances away from it. Do not touch bulb by hand while it is lit or right after being turned off. Burning may result.
  • Grasp only the plastic base when handling the bulb. Never touch the glass envelope. Touching the glass could significantly affect the bulb life and/or fog lamp performance.
  • Do not leave bulb out of fog lamp reflector for a long time because dust, moisture smoke, etc., may affect the performance of fog lamp. When replacing bulb, be sure to replace it with new one.
  1. Position the fender protector aside. Refer to "FENDER PROTECTOR ".
  2. Disconnect the electrical connector.
  3. Remove the front fog lamp assembly.
    • Remove the screw (5).
    • Pull the bracket (2) toward the rear of vehicle to release the snap clip (1).
    • Remove the front fog lamp screws (3) and remove the front fog lamp housing (4).
      Fig 1: Identifying Bracket, Fog Lamp Screws And Front Fog Lamp Housing
      G04908581Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals