LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 2123 (Brake Control System) >> Service Information >> Trouble Diagnosis >> CONSULT-III Function (ABS) >> Data Monitor >> Operation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Operation Procedure

WARNING: This page is about a different car, the 2008 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. After turning OFF the ignition switch, connect CONSULT-III and the CONSULT-III CONVERTER to the data link connector.
    CAUTION: If CONSULT-III is used with no connection of CONSULT-III CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carries out CAN communication.
  2. Touch "START (NISSAN BASED VHCL)", "ABS", "DATA MONITOR" in order on the CONSULT-III screen.

    If "ABS" is not indicated, go to "CONSULT-III DATA LINK CONNECTOR (DLC) CIRCUIT ".

    CAUTION: When "START (NISSAN BASED VHCL)" is touched immediately after starting the engine or turning on the ignition switch, "ABS" might not be displayed in the "SELECT SYSTEM" screen. In this case, repeat the operation from step  2.
  3. From the "DATA MONITOR" screen, touch "ECU INPUT SIGNALS", "MAIN SIGNALS" or "SELECTION FROM MENU". Refer to the following information.
  4. When "START" is touched, the data monitor screen is displayed.
scientia non olet · About LEMON Manuals