Diagnostic Procedure

WARNING: This page is about a different car, the 2004 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.

INSPECTION START
Do you have CONSULT-II?

YES or NO
1. YES: GO TO 2.
2. NO: GO TO 3.
PERFORM SELF-DIAGNOSIS (WITH CONSULT-II)
1. Turn ignition switch "ON". (Do not start engine.)
2. Select "SELF-DIAG RESULTS" mode for "ALL MODE AWD/4WD" with CONSULT-II.
3. Touch "ERASE".
4. Turn ignition switch "OFF" and wait at least 10 seconds.
5. Perform the self-diagnosis again.
Is the "CONTROL UNIT 1 [P1802]", "CONTROL UNIT 2 [P1803]", "CONTROL UNIT 3 [P1804]", or "CONTROL UNIT 4 [P1809]" displayed?
1. YES: Replace transfer control unit. Refer to TRANSFER CONTROL UNIT .
2. NO: INSPECTION END
PERFORM SELF-DIAGNOSIS (WITHOUT CONSULT-II)
1. Perform the self-diagnosis and then erase self-diagnostic results. Refer to SELF-DIAGNOSTIC PROCEDURE (WITHOUT CONSULT-II) and ERASE SELF-DIAGNOSIS .
2. Perform the self-diagnosis again.
Do the self-diagnostic results indicate AD converter?
1. YES: Replace transfer control unit. Refer to TRANSFER CONTROL UNIT .
2. NO: INSPECTION END