CONSULT-II Basic Operation Procedure

WARNING: This page is about a different car, the 2004 Infiniti M45. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition switch OFF.
Connect CONSULT-II and CONSULT-II CONVERTER to the data link connector.
Turn ignition switch ON.

Fig 1: Locating Data Link Connector
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "START (NISSAN BASED VHCL)".

Fig 2: Selecting "START (NISSAN BASED VHCL)" Screen
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "VDC" in the "SELF DIAG MODE" screen.
If "VDC" is not indicated, go to CONSULT-II DATA LINK CONNECTOR (DLC) CIRCUIT .

Fig 3: Selecting "VDC", "SELF DIAG MODE" Screen
Courtesy of NISSAN MOTOR CO., U.S.A.
Select the required diagnostic location from the "SELF DIAG MODE" screen.
For further information, see the CONSULT-II Operation Manual.

Fig 4: Selecting "SELF DIAG MODE" Screen
Courtesy of NISSAN MOTOR CO., U.S.A.