Removal And Installation

WARNING: This page is about a different car, the 2004 Infiniti M45. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing & Installing VDC/TCS/ABS Actuator

Courtesy of NISSAN MOTOR CO., U.S.A.

Pay attention to the following when removing actuator.

CAUTION:

Before servicing, disconnect battery cables.
To remove brake tube, use a flare nut wrench to prevent flare nuts and brake tube from being damaged. To install, use a flare nut wrench (commercial service tool).
Do not remove and install actuator by holding harness.
After work is completed, bleed air from brake piping. Refer to BLEEDING BRAKE SYSTEM .
Be sure to securely connect the ground cable.