Removal And Installation: Installation

WARNING: This page is about a different car, the 2003 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal paying attention to the following:

Surely clamp fuel hoses and insert hose to the length below:
1. Fuel filler hose: 35 mm (1.38 in)
2. The other hoses: 25 mm (0.98 in)
Be sure hose clamp is not placed on swelled area of fuel tube.
Tighten fuel hose clamp so that the distance between its lugs becomes to the following:
1. Fuel tank side: 2 - 6 mm (0.08 - 0.24 in)
2. Fuel filler tube side: 5 - 9 mm (0.20 - 0.35 in)
Push the fuel tank mounting band pin to the vehicle side securely.
Before fixing the fuel tank, temporarily install the filler tube.
CAUTION: Use genuine fuel filler tube mounting bolts or equivalent. Make sure to tighten them to the specified torque.
To connect the quick connector, refer to FUEL LEVEL SENSOR UNIT, FUEL FILTER AND FUEL PUMP ASSEMBLY .