AWD Control Unit System

WARNING: This page is about a different car, the 2003 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.

PERFORM SELF-DIAGNOSIS
WITH CONSULT-II

Perform the self-diagnosis. Is a malfunction in the CONTROLLER FAILREN indication in the results?

YES or NO
1. YES: GO TO 2.
2. NO: 1. Drive vehicle at 30 km/h (19 MPH) for at least 1 minute. Make sure AWD warning lamp does not turn ON.
3. INSPECTION END
AWD CONTROL UNIT CONNECTOR INSPECTION
Disconnect the AWD control unit connector. Check that terminals are not deformed. Check that the connectors were connected properly.

OK or NG
1. OK: Replace AWD control unit.
2. NG: Repair or replace the connectors.