April 5, 2026: LEMON Manuals is launched! Read the announcement.

With M/T Models

WARNING: This page is about a different variant/trim than selected.

Turn ignition switch OFF.
Disconnect stop lamp switch harness connector.
Check harness continuity between stop lamp switch terminals 1 and 2 under the following conditions.

Fig 1: Checking Harness Continuity Between Stop Lamp Switch Terminals 1 And 2
Courtesy of NISSAN MOTOR CO., U.S.A.

If NG, adjust stop lamp switch installation, refer to DISC & DRUM and perform step 3 again.