Actuator And Electric Unit (Assembly): Installation
CAUTION:
After installation of ABS actuator and electric unit (control unit), refill brake fluid. Then bleed air from system. Refer to
"BLEEDING BRAKE SYSTEM
".
- Position ABS actuator and electric unit (control unit) in vehicle.
- Install and tighten ABS actuator and electric unit (control unit) nuts and bolts.
- Install brake pipes to ABS actuator and electric unit (control unit), then tighten flare nuts. Refer to "HYDRAULIC CIRCUIT ".
- Connect ABS actuator and electric unit (control unit) harness connectors.
- Install windshield wiper motor and linkage assembly. Refer to "INSTALLATION ".
- Reconnect battery cable.