DIAGNOSTIC TROUBLE CODES Confirmation Procedure: Notes

NOTE: If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

WITH CONSULT-II

Turn ignition switch OFF and wait at least 10 seconds.
Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-II.
Start engine and wait at least 40 seconds
NOTE: Do not depress accelerator pedal even slightly.

If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE "

Fig 1: Identifying Consult-II Data Monitor
Courtesy of NISSAN MOTOR CO., U.S.A.