Overall Function Check

Use this procedure to check the overall monitoring function of the EVAP control system purge flow monitoring. During this check, a 1st trip DTC might not be confirmed.

WITH GST 

1. Lift up drive wheels.
2. Start engine and warm it up to normal operating temperature.
3. Turn ignition switch OFF, wait at least 10 seconds.
4. Start engine and wait at least 70 seconds.
5. Set voltmeter probes to ECM terminals 32 (EVAP control system pressure sensor signal) and ground.
   Fig 1: Chdcking Voltage At ECM Connector Terminal 32 And Ground

   Courtesy of NISSAN MOTOR CO., U.S.A.
6. Check EVAP control system pressure sensor value at idle speed and note it.
7. Establish and maintain the following conditions for at least 1 minute. Refer to Fig 2.
   Fig 2: EVAP Control System Pressure Sensor Checking Conditions

   Courtesy of NISSAN MOTOR CO., U.S.A.
8. Verify that EVAP control system pressure sensor value stays 0.1V less than the value at idle speed (measured at step 6) for at least 1 second.
9. If NG, go to "DIAGNOSTIC PROCEDURE ".