LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2005 >> Sentra SE-R >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake Control System >> Trouble Diagnosis - General Description >> Malfunction Code/Symptom Chart
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Malfunction Code/Symptom Chart

MALFUNCTION CODE (DTC) IDENTIFICATION

Diagnostic Trouble Code No. Malfunction Go to
12 Self-diagnosis did not detect any malfunctions. -
18(1) Sensor rotor WHEEL SENSOR OR ROTOR 
21(1) Front right sensor (open circuit) WHEEL SENSOR OR ROTOR 
22(1) Front right sensor (short circuit) WHEEL SENSOR OR ROTOR 
25(1) Front left sensor (open circuit) WHEEL SENSOR OR ROTOR 
26(1) Front left sensor (short circuit) WHEEL SENSOR OR ROTOR 
31(1) Rear right sensor (open circuit) WHEEL SENSOR OR ROTOR 
32(1) Rear right sensor (short circuit) WHEEL SENSOR OR ROTOR 
35(1) Rear left sensor (open circuit) WHEEL SENSOR OR ROTOR 
36(1) Rear left sensor (short circuit) WHEEL SENSOR OR ROTOR 
41 Actuator front right outlet solenoid valve ABS ACTUATOR SOLENOID VALVE AND SOLENOID VALVE RELAY 
42 Actuator front right inlet solenoid valve ABS ACTUATOR SOLENOID VALVE AND SOLENOID VALVE RELAY 
45 Actuator front left outlet solenoid valve ABS ACTUATOR SOLENOID VALVE AND SOLENOID VALVE RELAY 
46 Actuator front left inlet solenoid valve ABS ACTUATOR SOLENOID VALVE AND SOLENOID VALVE RELAY 
51 Actuator rear right outlet solenoid valve. ABS ACTUATOR SOLENOID VALVE AND SOLENOID VALVE RELAY 
52 Actuator rear right inlet solenoid valve. ABS ACTUATOR SOLENOID VALVE AND SOLENOID VALVE RELAY 
55 Actuator rear left outlet solenoid valve. ABS ACTUATOR SOLENOID VALVE AND SOLENOID VALVE RELAY 
56 Actuator rear left inlet solenoid valve. ABS ACTUATOR SOLENOID VALVE AND SOLENOID VALVE RELAY 
57(2) Power supply (low voltage) LOW VOLTAGE 
61(3) Actuator motor or motor relay MOTOR RELAY OR MOTOR 
63 Solenoid valve relay ABS ACTUATOR SOLENOID VALVE AND SOLENOID VALVE RELAY 
71 Control unit CONTROL UNIT 
(1) If one or more wheels spin on a rough or slippery road for 40 seconds or more, the ABS warning lamp will illuminate. This does not indicate a malfunction. Only in the case of the short-circuit (Code Nos. 26, 22, 32 and 36), after repair the ABS warning lamp also illuminates when the ignition switch is turned ON. In this case, drive the vehicle at speeds greater than 30 km/h (19 MPH) for approximately 1 minute as specified in SELF-DIAGNOSIS . Check to ensure that the ABS warning lamp goes out while the vehicle is being driven.
(2) The trouble code "57", which refers to a low power supply voltage, does not indicate that the ABS control unit is malfunctioning. Do not replace the ABS control unit with a new one.
(3) The trouble code "61" can sometimes appear when the ABS motor is not properly grounded. If it appears, be sure to check the condition of the ABS motor ground circuit connection.
ABS SYMPTOM/POSSIBLE CAUSE

Symptom Possible Cause
Warning lamp stays on when ignition switch is turned ON. Control unit power supply circuit
Warning lamp bulb circuit
Control unit or control unit connector
Solenoid valve relay stuck
Power supply for solenoid valve relay coil
Warning lamp does not come on when ignition switch is turned ON. Fuse
Warning lamp bulb
Warning lamp circuit
Control unit
Pedal vibration and noise SYMPTOM 5: PEDAL VIBRATION AND NOISE 
Long stopping distance SYMPTOM 3: LONG STOPPING DISTANCE 
Unexpected pedal action SYMPTOM 2: UNEXPECTED PEDAL ACTION 
ABS does not work SYMPTOM 4: ABS DOES NOT WORK 
ABS works frequently SYMPTOM 1: ABS WORKS FREQUENTLY