Removal and Installation: Removal

WARNING: This page is about a different car, the 2005 Nissan Altima. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the battery negative terminal.
Disconnect the accelerator position sensor electrical connector.
1. Pull the connector lock back to unlock the connector from the accelerator pedal position sensor as shown.
2. Pull up on the connector to disconnect it from the accelerator pedal position sensor as shown.
Fig 1: Pulling Up On Connector To Disconnecting Accelerator Pedal Position Sensor
Courtesy of NISSAN MOTOR CO., U.S.A.
Remove the upper accelerator pedal nuts and lower accelerator pedal bolt.

Fig 2: Identifying Upper Accelerator Pedal Nuts And Lower Accelerator Pedal Bolt
Courtesy of NISSAN MOTOR CO., U.S.A.
Remove the accelerator pedal and accelerator position sensor assembly.
CAUTION:
- Do not disassemble the pedal assembly. Do not remove the accelerator pedal position sensor from the pedal assembly.
- Avoid impact from dropping during handling.
- Keep the pedal assembly away from water.