Inspection Procedure

1. Turn ignition switch OFF.
2. Connect CONSULT-II and CONSULT-II CONVERTER to data link connector, which is located under LH dash panel.
3. Turn ignition switch ON.
   Fig 1: Locating Data Link Connector

   Courtesy of NISSAN MOTOR CO., U.S.A.
4. Touch "START" (NISSAN BASED VHCL).
   Fig 2: Consult-II Display - START (NISSAN BASED VHCL)

   Courtesy of NISSAN MOTOR CO., U.S.A.
5. Touch "ENGINE".

   If "ENGINE" is not indicated, go to "CONSULT-II DATA LINK CONNECTOR (DLC) CIRCUIT ".

   Fig 3: Consult-II SELECT SYSTEM Display Screen

   Courtesy of NISSAN MOTOR CO., U.S.A.
6. Perform each diagnostic test mode according to each service procedure.

For further information, see the CONSULT-II Operation Manual. 

Fig 4: Consult-II SELECT DIAG MODE Display Screen

Courtesy of NISSAN MOTOR CO., U.S.A.