Overall Function Check

Use this procedure to check the overall monitoring function of the EVAP control system purge flow monitoring.

During this check, a 1st trip DTC might not be confirmed.

WITH GST 

1. Lift up drive wheels.
2. Start engine (TCS switch or VDC switch OFF) and warm it up to normal operating temperature.
3. Turn ignition switch OFF, wait at least 10 seconds.
4. Start engine and wait at least 70 seconds.
5. Set voltmeter probes to ECM terminals 32 (EVAP control system pressure sensor signal) and ground.
   Fig 1: Checking Voltage Between ECM Terminals 32 (EVAP Control System Pressure Sensor Signal) And Ground

   Courtesy of NISSAN MOTOR CO., U.S.A.
6. Check EVAP control system pressure sensor value at idle speed and note it.
7. Establish and maintain the following conditions for at least 1 minute.
   AIR CONDITIONER SWITCH AND HEADLAMP SWITCH POSITION
   
   

   Air conditioner switch	ON
   Headlamp switch	ON
   Rear window defogger switch	ON
   Engine speed	Approx. 3, 000 rpm
   Gear position	Any position other than P, N or R

8. Verify that EVAP control system pressure sensor value stays 0.1V less than the value at idle speed (measured at step  6) for at least 1 second.
9. If NG, go to "DIAGNOSTIC PROCEDURE ."