Diagnostic Procedure

1. Turn ignition switch OFF.
2. Disconnect EGR volume control valve harness connector.
3. Turn ignition switch ON.
   Fig 1: Identifying EGR Volume Control Valve Harness Connector

   Courtesy of NISSAN NORTH AMERICA, INC.
4. Check voltage between EGR volume control valve terminals 2, 5 and ground with CONSULT-II or tester.

   Voltage: Battery voltage 

OK or NG 

OK: GO TO  3.

NG: GO TO 2.

Fig 2: Checking Voltage Between EGR Volume Control Valve Terminals 2, 5 And Ground

Courtesy of NISSAN NORTH AMERICA, INC.

Check the following.

• Harness connectors E5, F14
• Harness for open or short between EGR volume control valve and IPDM E/R

  : Repair harness or connectors.

1. Turn ignition switch OFF.
2. Disconnect ECM harness connector.
3. Check harness continuity between ECM terminals and EGR volume control valve terminals as follows.

   Refer to WIRING DIAGRAM .

   CONNECTOR TERMINAL CONTINUITY SPECIFICATION
   
   

   ECM terminal	EGR volume control valve
   17	6
   18	3
   19	4
   20	1

   Continuity should exist. 

4. Also check harness for short to ground and short to power.

OK or NG 

OK: GO TO 4.

NG: Repair open circuit or short to ground or short to power in harness or connectors.

Refer to "COMPONENT INSPECTION ".

OK or NG 

OK: GO TO 5.

NG: Replace EGR volume control valve.

Refer to "TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT ".

: INSPECTION END