CVT Device (Park Position Switch) Check

1. Turn ignition switch OFF.
2. Check for continuity between Intelligent Key unit harness connector M42 terminal 10 and ground.
   CONNECTOR TERMINAL CONTINUITY SPECIFICATION
   
   

   Connector	Terminals		Condition	Continuity
   	(+)	(-)
   M42	10	Ground	Selector lever is in "P" position	Yes
   			Other than above	No

OK or NG 

OK: Replace Intelligent Key unit. Refer to "REMOVAL AND INSTALLATION OF INTELLIGENT KEY UNIT ".

NG: GO TO 2.

Fig 1: Checking Continuity Between Intelligent Key Unit Harness Connector M42 Terminal 10 And Ground

1. Disconnect CVT device (park position switch) connector.
2. Check for continuity between CVT device (park position switch) harness connector M38 terminal 2 and ground.

   2 - Ground : Continuity should exist. 

OK or NG 

OK: GO TO 3.

NG: Repair or replace harness.

Fig 2: Checking Continuity Between CVT Device Connector M38 Terminal 2 And Ground

Check continuity between CVT device (park position switch) terminals 2 and 5.

OK or NG 

OK: Repair or replace harness.

NG: Replace CVT device (park position switch).

Fig 3: Checking Continuity Between CVT Device (Park Position Switch) Terminals 2 And 5