Changing CVT Fluid

Remove drain plug, and drain CVT fluid from oil pan.
Install drain plug with new gasket to oil pan and tighten to the specified torque.
Drain plug: Refer to "COMPONENTS ".

CAUTION: Do not reuse drain plug gasket.
Fill CVT fluid from CVT fluid charging pipe to the specified level.
Fluid grade and capacity: Refer to "MR20DE ".
CAUTION:
- Use only Genuine NISSAN CVT Fluid NS-2. Do not mix with other fluid.
- Using CVT fluid other than Genuine NISSAN CVT Fluid NS-2 will deteriorate in driveability and CVT durability, and may damage the CVT, which is not covered by the warranty.
- When filling CVT fluid, take care not to scatter fluid on heat generating parts such as exhaust.
- Sufficiently shake the container of CVT fluid before using.
With the engine warmed up, drive the vehicle in an urban area. When ambient temperature is 20°C (68°F), it takes about 10 minutes for the CVT fluid to warm up to 50 to 80°C (122 to 176°F).
Check CVT fluid level and condition. Refer to "CHECKING CVT FLUID ".
Repeat steps 1 through 5 if CVT fluid is contaminated.
CAUTION: Delete CVT fluid deterioration date with CONSULT-III after changing CVT fluid.