Diagnostic Procedure

Perform the self-diagnosis check. Refer to "SELF-DIAGNOSTIC RESULT MODE ".

Is any malfunction of the "U1000 CAN COMM CIRCUIT" indicated? 

YES: Check CAN communication line. Refer to "DTC U1000 CAN COMMUNICATION LINE ".

NO: GO TO 2.

With CONSULT-III 

1. Turn ignition switch ON.
2. Select "ECU INPUT SIGNALS" in "DATA MONITOR" mode for "TRANSMISSION" with CONSULT-III.
3. Read out ON/OFF switching action of the "BRAKE SW".
   ITEM NAME CONDITION CHART
   
   

   Item name	Condition	Display value
   BRAKE SW	Depressed brake pedal	ON
   	Released brake pedal	OFF

OK or NG 

OK: INSPECTION END 

NG: GO TO 3.

Check continuity between stop lamp switch harness connector E60 terminals 1 and 2. Refer to "WIRING DIAGRAM - CVT - NONDTC ".

Check stop lamp switch after adjusting brake pedal - refer to  "BRAKE PEDAL ".

OK or NG 

OK: Check the following. If NG, repair or replace damaged parts.

• Harness for short or open between battery and stop lamp switch.
• Harness for short or open between stop lamp switch and combination meter.

NG: Repair or replace the stop lamp switch.