Removal and Installation: Removal

Refer to the figure for key interlock cable removal procedure.

1. Place the selector lever in the "N" position.
2. Remove the selector lever knob. Refer to "SELECTOR LEVER KNOB REMOVAL AND INSTALLATION ".
3. Remove the IP center assembly. Refer to "INSTRUMENT PANEL ASSEMBLY ".
4. Slide the slider (A) toward the casing cap (B) while pressing tabs (C) on the slider to separate the slider (A) from the adjust holder (D).
5. Remove the casing cap (B) from the cable bracket on the control device assembly.
6. Remove the key interlock cable from the key interlock rod (E).
   Fig 1: Identifying Casing Cap, Tabs And Key Interlock Rod

   
7. Remove steering column cover (upper and lower) and instrument lower finisher. Refer to "INSTRUMENT PANEL ASSEMBLY ".
8. Pull out the lock plate (A) from the holder (B).
9. Remove the key interlock cable (1) from the key cylinder (2).
   Fig 2: Identifying Lock Plate, Holder And Key Cylinder

   
10. Remove the clip and then remove the key interlock cable from the vehicle.