DTC Confirmation Procedure

NOTE: If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next step.

TESTING CONDITION:

Open engine hood before conducting following procedure .
If any of following conditions are met just before the DTC confirmation procedure, leave the vehicle for more than 1 hour .
- Fuel filler cap is removed .
- Refilled or drained the fuel .
- EVAP component parts is/are removed .
Before performing the following procedure, confirm that battery voltage is more than 11V at idle .

WITH CONSULT-III

Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-III.
Make sure the following conditions are met.
FUEL LEVEL SE: 0.25 - 1.4V

COOLAN TEMP/S: 0 - 32°C (32 - 90°F)

FUEL T/TMP SE: 0 - 35°C (32 - 95°F)

INT/A TEMP SE: More than 0°C (32°F)

If NG, turn ignition switch OFF and leave the vehicle in a cool place (soak the vehicle) or refilling/draining fuel until the output voltage condition of the "FUEL LEVEL SE" meets within the range above and leave the vehicle for more than 1 hour. Then start from step 1).
Turn ignition switch OFF and wait at least 10 seconds.
Turn ignition switch ON.
Select "EVP V/S LEAK P0456/P1456" of "EVAPORATIVE SYSTEM" in "DTC WORK SUPPORT" mode with CONSULT-III.
Follow the instruction displayed.
Make sure that "OK" is displayed.
If "NG" is displayed, refer to "DIAGNOSTIC PROCEDURE ."
NOTE:
- If the engine speed cannot be maintained within the range displayed on CONSULT-III screen, go to "BASIC INSPECTION ."
- Make sure that EVAP hoses are connected to EVAP canister purge volume control solenoid valve properly.