DTC Confirmation Procedure
CAUTION:
Always drive vehicle at a safe speed.
NOTE:
If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next step.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:
Steps 1 and 2 may be conducted with the drive wheels lifted in the shop or by driving the vehicle. If a road test is expected to be easier, it is unnecessary to lift the vehicle .
WITH CONSULT-III
- Start engine (TCS switch or VDC switch OFF).
- Read "VHCL SPEED SE" in "DATA MONITOR" mode with CONSULT-III. The vehicle speed on CONSULT-III should exceed 10 km/h (6 MPH) when rotating wheels with suitable gear position.
If NG, go to "DIAGNOSTIC PROCEDURE ."
If OK, go to following step.
- Select "DATA MONITOR" mode with CONSULT-III.
- Warm engine up to normal operating temperature.
- Maintain the following conditions for at least 60 consecutive seconds.ENGINE SPEED AND COOLANT TEMPERATURE SPECIFICATION
ENG SPEED 1, 400 - 6, 000 rpm COOLAN TEMP/S More than 70°C (158°F) B/FUEL SCHDL 5.8 - 31.8 msec Shift lever Except P or N position PW/ST SIGNAL OFF - If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE "