DTC Confirmation Procedure

NOTE: If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next step.

Turn ignition switch OFF and wait at least 10 seconds.
Turn ignition switch ON.
Turn ignition switch OFF and wait at least 10 seconds.

CAUTION: Always drive vehicle at a safe speed.

TESTING CONDITION:

This test may be conducted with the drive wheels lifted in the shop or by driving the vehicle. If a road test is expected to be easier, it is unnecessary to lift the vehicle .

WITH CONSULT-III

Wait until engine coolant temperature is less than 90°C (194°F)
1. Turn ignition switch ON.
2. Select "DATA MONITOR" mode with CONSULT-III.
3. Check the engine coolant temperature.
4. If the engine coolant temperature is not less than 90°C (194°F), turn ignition switch OFF and cool down engine.
  - Perform the following steps before engine coolant temperature is above 90°C (194°F).
Turn ignition switch ON.
Select "DATA MONITOR" mode with CONSULT-III.
Start engine.
Hold vehicle speed at more than 70 km/h (43 MPH) for 100 consecutive seconds.
Check 1st trip DTC.
If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ."

WITH GST

Follow the procedure "WITH CONSULT-III" above.