With GST
- Start engine and warm it up to normal operating temperature.
- Check that voltage between ECM terminal 107 (Fuel tank temperature sensor signal) and ground is less than 4.2V.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
- Start engine wait at least 10 seconds.
- Select Service $07 with GST.
- Check 1st trip DTC.
- If 1st trip DTC is detected, go to
"DIAGNOSTIC PROCEDURE ".
Courtesy of NISSAN MOTOR CO., U.S.A.